Control panel: Setting filler wire and shielding gas

When you start the welding device for the first time or after a factory reset, the control panel will ask you to specify filler wire and shielding gas settings.

If you do not specify the filler wire and shielding gas settings, then only manual MIG process is available.

The selections are made with the two control knobs.

1.

Start by pressing the right control knob.

2.

Select:

>>  Filler wire material (the selection is made at two levels)

>>  Filler wire diameter

>>  Shielding gas type.

3.

Save the settings to a memory channel.

The same procedure applies when you try to select a welding process that does not support the set filler wire and shielding gas combination. In that case, start specifying wire and gas by long-pressing the Weld Assist button.